Search results

Hey Guys, I am looking for part numbers for the Searay temp sender, 1/4 NPT, not the 1/2" on top of the Cat engine. This one is for running the gauge on the bridge. I am also looking for the oil sender pressure, I believe it is a 1/8" NPT fitting. Any help would be appreciated. I see them on...

I am using Windward Power, former CAT guy, basically works only on CAT products and Westerbeke. He is a follow graduate from Mass Maritime, but I graduated years before him, they are located in Fairhaven, Mass. The insurance company is Atlantic Specialty Insurance Company.

Re: Smokey engine exhaust Hey Guys, This should be a good read. Well I reported last year on my smokey exhaust and went quiet, not sure if anybody noticed that, but the news was not good. Here is my story for who may be interested, perhaps some things to watch for as well. During the 2015...

Well the day has come, engine dead and requires pull out from the boat. Final root cause not 100%, but it looks like failed injector and washed out the cylinder in number 4 stbd side. My CAT guys were down this past Friday, found the bad injector, installed a new one, ran it up and nobody was...

Sounds good, I will join that forum.

Hey guys, First of all, sorry for the incomplete problem statement. The boat is back at my Marina and waiting for a CAT guy at this point. Here is where I am at. I am getting blue and brown smoke, engine vibration. Non CAT mechanic indicates running on 5 cylinders. Feels it as well. I also...

brown smoke, I am hoping a stuck or malfunctioning injector. Waiting on CAT right now.

Hey Guys, Launched the boat yesterday and experienced a very smokey stbd engine. I noticed engine and felt some vibration especially at lower speeds. Temps and oil pressure were good, fuel supply looks clean. At higher RPM's it seemed to smooth out. I suspect a sticky fuel injector. Any...

I had a similar problem several years ago, I assumed after doing all the checks that the motor had gone bad, even was suggested by Lofrans themselves. Spent a good hour with my fat head in the anchor hatch trying to pull the motor, after much battle, it was complete. Placed the motor in the...

I had the Tides system, after verifying I had flow before my fist launch this season some zinc became jammed into my water line and the unit was destroyed after a one hour run. I replaced the seal with spare seal, but the unit was distorted from the heat. Spare seal ready to go, but had to...

I just had mine replaced. My cutlass bearings required replacement as well. I spoke to Tides Marine and they suggested replacement of both and was willing to give credit for one with return of all parts. Have you used the spare seal located just in front of dripless. The guy from Tides was...

Call windward power in Fairhaven mass, 508 - 992. 0059 Westerbeke dealer

Hey Guys, Planning my first gear oil change on my Twin Disc transmissions. I see the manufacturer recommends SAE 40 oil. Anybody oot there have any "Watch Outs". Any specific oil or procedures to follow, how hard is it get the strainer out, etc.. Thanks in advance, Kontiki

Go to YouTube and type vacuflush

Dear all, My Westerbeke is now making oil, only got one year out of the impeller, replaced it this year. Now the unit turns itself off after an hour or so, I hope and suspect a bad water gear box unit and I am adding seawater, which is not good. However, I hope it is not not a cracked head or...

I have your information, CAT mechanic fixed mine. $20 solenoid. PM tomorrow and I will fax the schematic and part number for you. Pat

It may becoming time to look at your exhaust manifolds and risers, these engines should be running at no greater than 170. How many hours on the engines since the last replacement, when wascthe last dewater pump replaced. This is the classic scenario of pay now or play alot more later.

Hey Gary, I have the C120, can I dig thru there and I would assume to get to a calibration screen or set up. Please advise. Thanks, Pat

Dear all, Anybody have experience trouble shooting sea water temp sensors. I have the airmar transducer which does depth, speed and sea temp. My temp today was reading 91 degrees, boat is out of the water, however, it would read air temperature in previous years. Also, last Summer it was...

I will change the oil, I agree.