Search results

I have a 2000 340 sundancer. The exhaust manifolds need to be replaced. The bolts are rusted and cannot be removed by wrench. I plan to drill off the head of the bolt and remove the manifold off the stud. Problem being it seems impossible to drill the two inside manifolds. Therefore I want to...

I was down to check our 2000 340 today for the dreaded mouses and noticed that the battery charger was not on and the lights would not come on after energizing the system. The boat is plugged in and is showing on the panel. Blower works fine. There seems to be no power to the panel to run the...

when I winterized our 2000 340 this year I had the antifreeze run out onto the ground around the shaft. The port side was leaking considerably more than the starboard. Is this a issue with the drip less seal. If so do I need to pull the motors to fix it. Thank you for any input on this. Slow boat

I am changing the impeller on our 2000 340 with 7.4,s. Any advice would be appreciated from past experience. Thank You Slowboat

I have a 2000 340 and would like some direction on winterizing the ice maker.

Our vacuum flush is not picking up water It sound like it is trying. I am assuming the flush draws water from the lake and not from the water holding tank. Also is there anything different that has to be done at pump out compared to a regular heads.

I just purchased a 2000 340 sundancer. We are trying to set up the aft for sleeping but feel that we are missing something . There were two fibreglass section that came with the boat. One is a table that sets up between the two back bench seats and the other is a fibre glass section that...

I am ready to buy a 2000 340 sundancer with 613hrs. I have read post where owners were having issues with water getting into the motors through the risers. This boat has 7.4 MPI Merc,s. Any lessons to be learned here would be greatly appreciated. Thanks Slowboat.