Search results

I want to clean the deck down to the gelcoat, there seems to be yellowing, assumptively due to a build-up of wax, I have been told by the woody wax people that an alkaline based deck cleaner will remove old wax. I can not find an alkaline based deck cleaner. Anybody know of a brand?

Tracvision TV mount, I am thinking about installing a compact Tracvision Sat TV dome. I currently have a Furuno radar dome on my radar arch setting on a 5" forward leaning pedestal, I am intrigued about the best setup for our kind of boat to have the radar dome and the satTV dome in one...

I could not find a matching thread to this faucet at the hardware store. Anybody know where I can buy a replacement for the faucet that is in the cockpit sink.

Awesome, thanks

The knob on the pin that secures the Tuna door broke off. It is lost. In order to unlock that door, I need to get a good grip on just the pin, which is difficult to do by bare hand. Attached is a pic. The pin is below the bolt in the center. Anyone know where to get a replacement?

Our boat name, Emerald Eyes, is entirely right of the handle. I like the idea of an image on the left side. I’ll havta think about that.

My big one is plugged and used to store downriggers and other fishing equip. That drain plug holds very well. If I disconnected the hose, I would also put an end cap on it, to be conservatively redundant.

Are you askin about the big box or the little box?

Still running the original stuff, except I had to replace the mother board which is in that corner. We all know where it’s at. That cost $800 installed. On this topic, I also tape dryer sheets all around the air return areas under the stairs to filter the air going back to the a/c.

Autopilot question: Finally launched our boat today in Chicago, (all Chgo harbors still not open), but I got out. My B&G network pilot had a display message: rud drv. I could not use the autopilot, but manual steering was fine. I’m guessing this means rudder driver. Is this a diy, a small...

I followed your link and looked at that faucet. I actually have a similar faucet in my bar sink at home. It is not a very busy install. Now that I know I can get to it, I'll just have to contort my body to get inside the cabinet to get er done. My back is sore just thinkin bout it. Thanks,

My galley faucet is leaking whenever the hot water is turned on, but not leaking otherwise. I think the faucet is a Scandvik standard galley mixer. I see the slow leak coming out thru the hot water knob. I can not figure out how to pull that knob to check the inside for the source of the leak...

I will be replacing a thruhull transducer & faring block with a new ducer and block. The old one was in there when I bought the boat 12 years ago. Any issues with using the existing hole and existing faring block to mount the new transducer? How does one actually remove the old transducer...

I will be replacing a thruhull transducer & faring block with a new ducer and block. The old one was in there when I bought the boat 12 years ago. Any issues with using the existing hole and existing faring block to mount the new transducer? How does one actually remove the old transducer...

When I took my boat for a ride 2 days ago, the starboard engine ran fine, but only up to approx. 2400 rpm. I like to cruise at 3200 rpm and have not had any acceleration issue before. This last time; however, the engine did not respond to more throttle. it got sluggish as I gave it more...

There are approx. 750 hours on the engines. Tks

The mechanic in the boatyard where I store my boat for the winter indicates there is oil leaking from the timing chain covers and the oil pan forward seals in both engines. The boat is a 1998 370 Express and the engines are the original 7.4 horizons. The mechanic says that both engines need to...

GCHOG: I originally used adjustable "oh-shit" poles, and the wind bent them in half, two of them! Creekwood: Your setup looks to be spot on! Does your boat neighbor have the same thing? Where did you get the poles? And the canvas customized to fit? saopm: Was that sunfly setup made to...

I am planning on making a "patio" umbrella to cover the rear end of my cockpit. I have a 1998 370 Express, with a large and wide cockpit. I already have a bimini fore and aft of the radar arch. The boat has built in rod holders on each side. I'm thinking of conduit or something similar in...