Search results

  1. M

    Hi-Tek Manifold installation

    Hi All, I have recently purchased a set of stainless manifolds from hi-tek for my 5.0L MPI. However, after two hours of mucking around with the head bolts in I have only manage to get the outer two in and I am thoroughly stumped. There doesn’t seem to be enough room for me to even get the bolts...
  2. M

    sacrificial anodes in block

    Hi All, I have a raw water cooled 5.0L MPI in my sea ray amberjack. My question is are there sacrificial anodes in the cooling passages protecting the block. If so where are they located and is there are recommended service interval for use in salt water. If not then how is the block...
  3. M

    Service life of manifolds and risers

    Hi All, I was recently on a trip to some offshore islands here in Oz and my engine over heated. Turned out is was due to blocked water passages in the risers. I took them off and soaked in acid which cleared the blockage but also removed a lot of flaky material as well. Through my research...
  4. M

    Flushing trailered I/O without Muffs

    Hi All, I have a Sea Ray Amberjack with a mercruiser 5.0L coupled to a Bravo 3 (trailered). This is my first I/O boat and so I am taking some time to get used to all of the differences to outboard boating. I do 100% of my boating in salt water and so have recently found out about the...
  5. M

    Blown Fuses

    Hi I have a set of Bennett trim tabs on my 250 Amberjack. I am having trouble where the Starboard side will go up and down find but the Port side will just blow a fuse as soon as I press the button in either direction. I have previously had an issue with a “dry” electrical joint in the switch...
  6. M

    Posting Pictures

    Hi, I have a question about my trailer that I would like to post on the forum but it really needs the photos to show what I am talking about. Is there anyway for me to post photos directly from my computer (macbook) to the forum without using photobucket or similar? Cheers
  7. M

    bow roller

    G'day, I have recently purchased a 2006 amberjack 250 here is Australia and I reckon it is a fantastic boat. far and away more refined than any thing I have owned before. I do however have two problems with it that are driving me nuts and I was hoping for some advice on what to do. 1) It...
Back
Top