Search results

On a Sea Ray 34, one of the hoses came loose, due to a clamp failure and soaked the engine conpartment with salt water. Now the engine is missing above 2800. It most likely is missing below, just do not notice it. It starts fine and there is no solid miss, you can see the sync gage moving...

Carter, Thank you very much

Vandal, Thank you very much, I must have a loose connection or wire somehwere. If anyone out there has any suggestion on where to look for loose wires or conectors ssure would appreciate. I can not find a detailed wiring diagram for the cabin light wire runs.

On a 2000 34 Sea Ray sundancer there are two switches to the right of the cabin door. One switch controls the back cabin lights and I think the other controls the main cabin lights, including the front bunk. The lights in the main cabin and front bunk wil not come on and they are missing the 12...

Thanks Capts. I now have a great feeling that it will work. I have a local electronic installer advising me to use a two part epoxy and just expoxy it to the inner hull after was sanded and cleaned with Acetone. Thus implying not to use the anti-freeze reservoir. Anyone installed it in...

I am considering going with a Garmin P79 in-hull transducer on a SR 34 Sundancer. Has anyone done this ? If so does it ?:huh:

Bt Doctur, Thank you so much, that was great information

Dicor, I agree with that , but the engines seem to run about 10 degree's warmer after I instaled new thermostat yesterday. I was thinking that maybe the rubber gasket was there to provide heat insulation from the top cover for the thermostat. It seems if it were to be a just a gasket it would...

Does anyone know the purpose of the rubber gasket that the thermostat sits on in the thermostat housing ?

Does anyone know the value of the rubber gasket above the thermostat in a 7.4. I just replaced my thermostats and that gasket was gone and I did not replace it. Motors run great, but I do not hae that bloody rubber gasket in the housing. comments anyone ??

Happy Hour IV, Can you share the other three steps ?

Happy Hour IV, I will order new ones and install them with new hoses. Thank-you very much. Wayne

I helping a fellow with a 34 Sea Ray with 7.4's, the boat was run with out water and damaged the resonators and exhast hoses. Do you need the exhaust Resonators ?? They are located midway down the exhaust hoses and held in place by a external hose clamp. Does not seem to be a critical element...

I have a 34 with 454 and they ned to be replaced, I have removed 7 of the eight bolts on each side and yes there is one to go on both sides. The bolts head are rusted and the socket keep slipping, I am thinking about using a grinder to remove the head and then manifolds are off I will hopefully...

Will run wires direct to motor tomorrow to see if that gives her a turbo boost.

No I did not, both engines start very nicely and when I hit the hatch switch and watch the voltage meter in the cabin, they stay above 12 volts. Wacky problem,

I have a 34 SR and the hatch motor is slow going up and down. When I measure the voltage at the motor it goes from 14V to 7V on the lift and 14V to 9V on the downard movement. I have checked the easy to get at connections. Has anyone seen this before, I hate to order a new motor for it and...

Thanks Much Nor Cal !!:smt038

So a 2000 should do the counter rotation in the Vee-Drives I guess. I am going down this week and start the engines and see if they both rotate the same way, Comments are welcome and Thank you

Does anyone know if a 2000 Sea Ray has counter rotating Engines or does it do the counter in the V-Drives ?? I am asking as I must replace the Sea Water Pumps. Thanks Much in advance