Search results

I'm looking for someone who can repair my Onan generator in my 1990 Sundancer, in Southern California; specifically Riverside or Orange Counties. I tried the Onan distributor in Irvine but they weren't much help. It hasn't been started in at least 2 years; last time I was able to start it, it...

Looking for good generator mechanic in Orange or Riverside County for my Onan First Mate generator. Any help would be greatly appreciated! Thanks; Pete (guitarfish)

I'm looking for someone who can repair my Onan generator in my 1990 Sundancer, in Southern California; specifically Riverside or Orange Counties. I tried the Onan distributor in Irvine but they weren't much help. It hasn't been started in at least 2 years; last time I was able to start it, it...

HOW DO I TIGHTEN my IMPELLER BELT? Anybody have or know of diagrams I can download that will show the components and belt routing? It's really hard to see the front section of the engine in the engine compartment, so diagrams would be helpful. It's a Bravo 3 Magnum engine/outdrive. Thanks...

Where/how do I tighten the belt that controls my water pump/impeller? I have a Bravo 3 Magnum engine. Thanks for any help in advance!! :smt038

Looks like I need to install a new In/Down Trim Hose (starboard side), since mine appears to be leaking (oil). Question is, do I need to remove the trim cylinder to do this? It's a 1990 Sea Ray, 27', mercruiser bravo III. Any suggestions for parts sources and/or part number? Thanks...

Looking for a hinge for the right side door under the sink on my 1990 27 DA . Part number appears to be 521336 - - owner's manual says this is the part number for the door (including hardware?) ~ ~ Probably don't need the door, just the hinge, although the wood where the hinges are attached...

WATER LEAK in aft berth: I have a water leak in the aft berth on my 1990 270DA Sundancer; it shows up on the wall on the port side of the aft berth (upholstered) wall. It shows up if it rains, if I wash the boat, or if we go boating in rough weather/rough water. I've sealed every nook and...

I have a 1990 Sea Ray 270 DA /Sundancer that has an Onan 3.0 First Mate Generator. ( I assume it came with the boat originally). It worked okay until recently. The last couple of times I ran it, it shut off after about 15 minutes. My first suspicion was overheating, but it seems to be drawing a...

Thank you to Paul of boatservices.com for helping me with my first post on CSR! New problem: (Anchor Windlass Problem): I have a 1990 27 Sundancer, bought used in 2009. (Previously) When I hit the "down" position on my anchor switch, the anchor would release, and go into "free spool" (for...

Not new to boating, but new to CSR and a fairly new Sea Ray owner (older Sea Ray, 1990 270 DA Sundancer). Located in So Cal, use the boat to go to Catalina as often as possible, occasional cruises in Newport Harbor, and some fishing out of San Diego. Looking forward to help from other CSR...

I have a 1990 270 DA Sundancer. The boat has little (8" x 3/4") gray plastic vent covers at the bottom of the windows on each side of the boat (3 per side), presumably for ventilation of the cabin, with gaps at the bottom of the vents to let air in, but to keep water out. I need at least 3, but...