Search results

  1. E

    1993 SunSport 310 Engine hatch question

    1993 Sea Ray SunSport 310. Wonder if anyone can assist or point me to the correct forum. Had some work done over the winter and now the electric cylinder only opens the engine hatch a few feet. I haven't used the boat much this year and was told there is a part missing. The mechanic is no longer...
  2. E

    Re finishing forward berth question...

    1988 30' Weekender and have some stains on upper sides of vee berth. This caused by the forward quarter gunwales or stanchions leaking leaving a huge stain. I'm not sure what the material is and doesn't seem too damaged to the touch just the stain. Have removed the upper trim which showed a damp...
  3. E

    Thunderbolt IV Amplifier question

    Hi all, 1988 30' SeaRay Weekender with 2x 260hp 5.7L's Mercruisers. I needed to run the engine without starting so I removed the wire from the top of the HT Coil. I noticed a spark from the center over to one of the terminals. After reconnecting everything I get no spark. Could I have fried the...
  4. E

    Removing back rest for re-upholstieing.

    1988 30' Weekender, Vee berth needs re-upholstering and trying to figure out how to remove the (what I call) back rest around the bed and the board that runs around the top. They have decorative buttons, is this where the fasteners are hidden? Any suggestions would be very helpful. Thanks -Dave
  5. E

    Electrical diagram 1988 30 Weekender 2x 350 inboards

    Can anyone help me locate an electrical diagram 1988 30 Weekender 2x 350 inboards. Many thanks .....Dave
  6. E

    Interrupter switch replacement

    Buddy has a 1981 26' Sea Ray with 260hp and the interrupter switch is defective. Needless to say Sea Ray caught on to the fact this $6 switch is going to need replacing on most of these models so they discontinued this very simple switch and redesigned a whole bracket with a different switch...
  7. E

    Sender/Gas Tank Removal

    1988 30' Weekender 300 with 2x 260hp straight shafts. I have been babbling about my frustration with a sending unit in my stbd gas tank and spent the last few days preparing to tackle some troubleshooting. Covering the engine so I can climb around on it I finally had to cut the 4" blower hose to...
  8. E

    1988 30' Sea Ray Weekender

    Hi all. I am looking for a wiring diagram for my Sea Ray and I seem to be search all the wrong areas. I followed the sticky and it mentions "Service Tab" and cant seem to find it. I followed a customer service and seem to be filling out my name and address etc and are prob going to mail it. Does...
  9. E

    Identify water hose fittings help

    1988 30 foot Sea Ray. Need to replace water connection between a cold water tee to the hot water heater. Approx 12 inches long with fittings no one can identifiy including our local Sea ay dealer. All other similar Sea Rays in the club has same fittings. Is there a supplier anywhere that I can...
Back
Top