Recent content by Slimcobra

I have been thinking about completely redoing my dash. I was thinking about a 7 inch nav unit right in the center. Them getting new gauges and have one of them be a 4 in one for water temp, oil pressure, volts, and fuel. This should free up the space I need in the middle of the dash.

I had family in town and they wanted to go out on the boat. It had been a while since we had taken it out so I put some muffs on it and ran it at home for a bit. Everythiong was fine on the dash but the water pump seemed to be making noise. We took it out anyway and to no surprise we over...

I want to remove and paint the emblems on the side pocket panels of my 210 sun deck but I'm not sure how they are attached. I don't want to pry to hard on them and snap them. Has anyone removed the emblems before?

When I bought our 2000 210 the cooler was not there. Found the one that came with the boat and I kid you not the third time I used it the handle ripped off the side of it. I had another cooler on wheels that was slightly bigger and didn't fit in the rails so I moved the rails over to...

The Starbrite was ok but I have some areas I need a little extra punch to get completely clean, but thanks.

Who's tried them and what did you think?

Rob Q how bad was the starter replacement? It looks like it's time for me to replace mine.

It looks like I need a new starter so I started searching the internet for one. It looks like I can get it cheaper from Amazon, but I feel bad not supporting marine suppliers. I feel like the $5-10 dollars more through a marine supplier just makes more sense in the long run. What are your...

Agreed, if I found that I would replace the coil, distributor cap, wires and plugs. That coil is a bitch to get out. Do yourself a favor and remove the seat base, the risers and manifolds. Once those are out of the way you can have the rest done in an hour or less. When you go to put the...

Yeah its tight. Would I be able to order the Sea Ray through Marine Max.

It should be a throttlebody.

My bracket on my 2000 210 Sun Deck has become fatigued and bends when you close the hatch. Has anyone had to replace this and where did you get the part from? I have done a search for the part number and part name and not finding the Sea Ray part. 634550 BRACKET, SS GAS CYL 90DEG L-BRKT...

Rob, I have the same boat and I wish I had some kind of an answer for you but I don't know. I'll be following to see what the answer is.

It doesn't run any more and it's so rusty it looks like it's going to fall apart any second. Definitely time for a replacement.

My Shurfo 8050-224-133 bit the dust today. The pump is rated for 1.6gpm at 30 psi. The closest I can find is a 60psi. Will that be ok to use?