Recent content by Pair-A-Dice

Hello, Excellent job installing the Allure Ultra flooring! I am also considering installing the same flooring in my "02 340 Sundancer. I have a few questions I'm hoping you can answer. 1, What effect does extreme cold have on the flooring? Does the floor show any signs of contracting and...

I have the same issue on my Starboard 8.1L Horizon. Here are some parts have I replaced that did not solve the issue. Hopefully this can save you some money on parts. Both high and low pressure fuel pumps and fuel cooler. Also changed both in-line fuel water separators, and swapped out relay...

Hi, I was reading your post, and am having similar stalling issue on my starboard 8.1 . Although I have the Gen2 cool fuel module. Mine stalls at both harbor and also when getting on plane. What exactly did you do to bypass your solenoid? I only have 1, just out of the tank. Thanks, and good...

I am having a similar problem on my 8.1 starboard engine and I have measured the fuel pressure on the Schrader valve on the fuel rail. Mine was reading 35psi, and the specs I believe are 40psi +/- 2psi. That may have something to do with the issue. Are you stalling at harbor speed (lowest...

I have 2 issues with my unit. 1, The right half of the screen cannot be seen. So it is impossible for me to scroll through the screens to set up the unit as a slave. 2. My unit is frozen and will not cycle or power down. I have to pull the power plug from the back to power down. So I am not even...

Hi, my current RN 300 is on it's last legs...does anyone have a working unit they are looking to sell??

I had my boat winterized from a local marina in the fall. I just launched the boat, and my impellers are not pumping any raw water. )Luckily I caught it right away before overheating the engines). The impellers are paractically brand new last year with about 15 hours on them before the boat was...

I will check into that also. My drain plug is not installed so it could have possibly leaked out of the bilge into the gravel where my boat is sitting>

I will try that. I hope your bet is right!! Thanks for the suggestion!

Both engines have had coolant replaced in the last 2 years.

I just found this issue, and the marina is not opened today. I will be calling them on Monday.

Ok, I am stumped on this one...I had my Merc 8.1's winterized by a local marina where I store my boat. I have closed cooling on both engines. I have just noticed both coolant reservoirs are empty, as I was getting the boat ready to launch. Both reservoirs were full when I drove the boat there to...

Hi Mike, Not sure if the mic/radio is still available (can't tell from the latest replies) If it is available, I am also interested. I do have the 210 model also. Thanks!

I will verify whether the transducer is on or through hull, nd if it is obstructed. Thanks for the reply!

My ST60 Tri Data Depth readings seem to be somewhat accurate when under power, but when moored in my well show at least 15 feet deeper than actual water depth. Anybody else ever have this issue? I am not sure if it is the transducer, or the display causing the issue. I believe my transducer is...