Recent content by GrimmSpeed

Looks great! I followed that same post on Sailnet this year and it turned out great as well. Maine Sail knows whats up.

I did this last year. Turned out awesome. I needed to have my local canvas shop make a couple small changes to get it to fit better but I still saved 50% over anyone else.

Thank you for the tips guys! I will try them and get back to you. Also, I will check what model of pump we have.

Last summer was our first summer with a child on board. It became apparent that the vacuflush was way to loud and would wake up the baby. I'm looking for a solution to quieting this down. It's not the pump running that makes the loud noise, it is the initial pedal push that opens the valve to...

Check out our 330/340 Express Cruiser thread here on CSR!

Imar

I run mine while underway.

I put seadeck under mine and just leave them on the whole year. It is important to get the cushions off of the gel coat so the moisture doesn't sit there. I clean regularly when I do the rest of the boat and then once or twice a year I do a heavier vinyl cleaning.

Were you able to find a cockpit fridge that is fridge only? I've been trying to find either a fridge only or freezer only(preferred) to replace the existing old ice maker. What brand did you go with?

I've done this a few times. Current setup is a 28" Samsung Smart Tv mounted on the port side of the radar arch. I used a low profile flat screen mount directly bolted to the fiberglass (no extra supports). These TVs are so crazy light these days so I wasn't too worried about that. You'll want to...

Anybody working on any fun projects this spring? I'm trying to pick out a wood grained vinyl to cover the cabin cabinets. That's about all I have going on.

He's not super close to you but he's the best I know: http://www.s2marineservices.com/expertise.html

Any chance you can find the "330" font that is on the stern (upper right corner) of a 1998 330 Express Cruiser (Amerbjack)?

What is everyone doing for rear fenders? There is no cleat for a fender. Ideally we'd have a cleat by/near the rear flushmount rod holder. We don't use the rod holders so as of now I just took off the bottom cap of the rod holder tube, then put the fender line in the rod holder and out the...

We put one on our 260. They are great for keep the gel coat from getting scratched up. I wouldn't assume there is a problem, they probably just put it on as a precautionary.