Recent content by FYN409

Yea, not to burst your bubble but I would avoid Fram filters at all cost. They used to be good filters until they switched to an overseas manufacturer. I agree with Gunn get a Wix (or Napa Gold), one of the best out there. -Ryan

You have a long No-Wake zone ride up the Grand River and first part of Spring Lake. I would say that will add 30-40 minutes to your calculation.

Very nice, looks like someone took good care of her!

On the tabs subject, what brand are the ones you are using?

Yea, we went Thursday night. It was nice to see some boats and start getting back into the boating mood, but I agree it was lame. Each year there are less and less cruisers and more and more pontoon and ski boats. We boarded a total of three boats to look around. How many models of pontoon...

Well said Old Skool! -Ryan

I am using the Democrat motto "Vote Early, Vote Often"........ :grin:

I cast my vote for you!

We are hoping to go out for one last cruise of the season this week. With that we would like to visit Saugatuck for a few hours and walk around at the shops. Is there a good place to tie up for a few hours near downtown? Last time we did this the marina on the north side let us tie up but...

Depends on how much skiing you plan on doing. My wife occasionally ski's behind our 26' Sundancer, but it's not something you would want to do all day or with a lot of people. I have the 7.4 liter with an Alpha1.

I hate to admit it, but AMEN! Scarey.... I am feeling old......

A hole saw chucked up in a drill would probably be best for cutting it. Just keep the speed slow so you do not "shatter" the plastic, or melt it. Same goes for the fiberglass. You can see behind the fiberglass correct? You should be able to steer clear of any cables then. You may want to...

Wow, 73 degrees on Superior has to be close to a record! We just spent 2 weeks up on Torch Lake (deep lake just east of Grand Traverse Bay) and the water was 78 degrees on most of the lake. Talking with some of the locals they said they can not remember Torch ever being that warm.

Actually, is that a depth gauge in the picture on the right of the dash, hidden by the top of the windshield? That appears to be a nice place.....

That was my thought as well, and external cup for the gauge and mount either near wheel, or on top of dash (if there is room) otherwise how about flush mounting it on the flat area of fibreglass to the left of the wheel? You would just need a hole saw the size of the gauge. -Ryan