I have twin 1997 7.4 L MPI engines on my 370 Sundancer
I am wondering if you can receive data from these engines and send it to a multifunction display?
Has anyone done this?
if so what would be required to do this?
Thanks in advance
Chuck
I have twin 1997 7.4 L MPI engines.
I am wondering if you can receive data from these engines and send it to a multifunction display?
if so what would be required to do this.
Thanks in advance
Chuck
40 ft slip at rivers edge yacht club Grand Haven Michigan.
45 minutes from Lake Michigan.
water and internet included. Metered electric.
inground pool nice clubhouse with bathrooms.
April thru October $1700 total
My 7.4 MPI engines on my 97 370 burn about 30 gals per hr. When I cruise at 3400 RPM.
right around 26 MPH. Which equates to .8 miles per gallon at cruising speed.
I have a question I hope someone can help me with.
last weekend I had the bilge pump alarm go off in the bilge under the salon floor.
never had water there before ever. Water was coming through the stringer on the port side.
The pump would kick on about every 50 mins. I turned off the water at...
I have a 1997 370 with 7.4 MPI engines.
my starboard engine this season lost power above 3000 RPMs.
i changed the plug wires per the suggestion of another club Searay member and it solved the issue. I see where you said you changed the plugs. I would suggest changing the plug wires.
they are...
I have too agree with AMFM3.
we bought our 97 370 Sundancer 4 yrs ago.
it has the Hurth V Drives as well and I love them.
The boat is fantastic! We too will keep ours for a long time.
unless someone is going bigger I can't believe anyone would sell these awesome boats.
To the advice from Mark.
i changed the wires on my engine and it fixed the problem.
i could not get above 3000 rpm and Mark suggested wires.
pretty cheap and pretty easy.
Just an update.
i have not been able to get to the boat until this weekend.
I added new plugs and wires on the Starboard engine.
It now runs like new.
Thank you for your input Searay Mark. Much appreciated.
i have ordered wires and plugs for Port engine. That way both engines are on the same...
Sorry about the late reply back.
i had family issues that kept me from the boat until this weekend.
here is the update.
i changed the plugs and wires on the Starboard engine as suggested.
Boat runs like new now. Problem solved.
ordered another set of plugs and wires for the port engine so I have...
I just installed the Clarion M502 unit in my 370.
i love the Bluetooth.
i was able to match the color coded wires from the old unit to the new one.
i had to run a new cable for the remote and enlarge the opening where the old one was.
all in all not a bad install though
I am having the same issue with my Starboard engine on my 370 sundancer with 7.4 MPI.
i put new plugs in last year. They have about 75 hrs on new plugs.
they ran flawlessly until about a week ago. I noticed the Starboard side was down on power.
i have changed the fuel filter/separator, but that...
Changed the fuel filter this weekend. That made no difference.
next weekend is plugs and wires since I didn't receive them in time this last week.
i did notice more of a vibration than normal and still will not rev above 3000 RPM.
so I am hoping plugs and wires will fix the issue.
Thanks
Mark,
Is there anyway to figure out which plug or wire is bad? Or am I best off to just replace all of them.
where can I purchase wires for Marine 7.4 M.P.I.?