Hi Blueone. I have same issue. But the cable appeared to connect into a sealed unit behind the cradle which then feeds the radio and separately the speaker. Just confirming how easy this was to obtain and replace?
I have some mild weather cracks on top of rear bench seat by transom door. No where near ready change out. Looking for solution to cover / seal up. Anyone have positive experience doing this?
The Waeco 1.6CF freezer on my 42 Sundancer works well when plugged into shore power but warms up to 0-1C when on DC. Compressor is a Danfoss D35F 101Z 0200 with controller 101N0220. Test light flashes 2X suggesting fan overload cutting off compressor but I have replaced fan already and no...
Helpful answer.
Are you installing 10X 100ah LiFePO4 ? The momentary discharge charge rate is 200aH for single battery. What do you believe would be required for just a single port diesel engine?
The idea of simply replacing the port with a 200ah or 300ah lithium would meet my...
Can anyone advise how to separate house loads from Port starting battery on Sea Ray Sundancer 42? I want to install Lithium for house and solar but these are not ideally suited for starting diesels .
Pulled freezer and downloaded compressor manual for the Danfoss BD35F. This is a simple diagnostic led connection that flashes codes 1-6. As the only part that can be replaced is the controller, I am going ahead with that. I do note that the battery protection circuit can be varied to allow...
Freezer runs well on 120v. Can hear compressor operating on 12v but even with full batteries the freezer starts warming after just a few hours. Freon is filled property.
Thoughts?
Has anyone found a suitable replacement freezer, or retro-fit of parts for the freezer?
Attempted to recharge but not solving problem. Not cold and consuming a lot of energy under batter power. Marginally cold under shore power.
Just hit a log floating in the high Waters of Lake Ontario. Debris everywhere
Developed a shake and dove in to see 1/2 of one of the 4 blade props is missing. No other apparent damage. Can anyone recommend what prop (s) I should consider as replacement?
Has anyone calculated optimum cruising RPM based on Cat 8.3 power curve and hull design?
Continually need to recalibrate auto pilot each restart of engines? Any advice?
I continue to get a "needs calibration" message on a Raymarine RL80C. Seems to lose compass calibrations on each restart. Went through the process a couple of times but want to fix. Ideas?