Recent content by BKRUSE47

  1. B

    Horn Wiring Access in cabin of 1991 Sundancer 270 DA

    Turns out the brackets are the only hardware securing the storage compartment/panel. Had to cut the headliner to access the horn wiring. I cut the wire back and had all clean copper. Did a test run and connected the new horn to the clean wires. Still I have 12Vdc at the wire but the horn would...
  2. B

    Horn Wiring Access in cabin of 1991 Sundancer 270 DA

    Hi, I need to access the horn wiring from inside the cabin ceiling of my 1991 SeaRay Sundancer 270DA. It has a storage compartment/panel. Inside the storage door I can see two brackets. One toward the back of the boat and one about midway of t panel which I can access. However, for that...
  3. B

    Raw Water Pump impeller

    I have a 383 MAG stroker motor in my 1991 Sea Ray Sundancer. How do you change the impeller? I see the raw water pump, but don't see the bolts to remove the pump. Is there someplace I can obtain an exploded view of the pump assembly. Thanks, Bryan
  4. B

    Alarm Location on 1991 270 DA Sundancer

    Thanks very much for the input. This is a great help. I'll check it out. It sure would have been nice if Sea Ray would have had an electrical wiring diagram for the boat. Oh well. Your help is greatly appreciated.
  5. B

    Alarm Location on 1991 270 DA Sundancer

    Hello All, Hope someone can help me here. I have a 1991 Sundancer and had a 383 stroker motor installed by the Marina where I dock my boat. Where is the alarm located? I imagine somehwere under the dash. Tried to get wiring diagram from Sea Ray, but not joy. Since the Stroker was...
  6. B

    Sliding Window 1991 270 DA Sundancer

    Hello fellow Sea Ray owners, I have a 1991 270 DA Sundancer that has a broken sliding window on the starboard side (self inflicted, another boats anchor punched through and broke the window). The window isn't available any longer from Taylor Made, but I have found that it is plexi glass Bronze...
  7. B

    I have a 1991 Sea Ray 270 DA to which I broke the sliding window on the starboard side. I need...

    I have a 1991 Sea Ray 270 DA to which I broke the sliding window on the starboard side. I need to replace it. Anybody out there know the process to remove and replace the slider window.
  8. B

    Removal and Replacement of Slider Window

    Hello All, I have a 1991 SeaRay Sundancer which I just purchased. I accidentally broke the starboard side slider window and would like to know the procedure to remove and replace it. Can anyone give me some input on how this is to be done. Thanks, Bryan
See more
Back
Top