Bill O'Neill
New Member
I have a 96' 330. The engine room hatch lift system is weakening and I think I need to replace it. Any thoughts? Rebuild in the winter, replace, purchase a rebuilt unit? Thanks guys.
Engine hatch lifter
- Thread starter Bill O'Neill
- Start date
rcknecht
Well-Known Member
If it is a Werner Electric Actuator like I have, it is not produced anymore. There is a replacement. Contact Werner and they can tell you the P/N of the replacement. Then go online and fine a distributor with one... I found my replacement for 1/3 the cost of buying it through sea ray... As it turned out... I greased mine and it has been working and I have not replaced it yet...
Bill O'Neill
New Member
Thanks for the tip. I will try greasing it first.
rcknecht
Well-Known Member
this is my actuator and its replacement:
Warner Electric
Old discontinued model: DM12-10A5-18 (no parts)
Replacement: K2 G10-12VM BR-18
Warner Electric
Old discontinued model: DM12-10A5-18 (no parts)
Replacement: K2 G10-12VM BR-18
Kreole Kid
Active Member
- May 25, 2009
- 1,710
- Boat Info
- 2004 340 Sundancer - SOLD
2008 Yamaha VX1100 Jet Ski - SOLD
BOATLESS
- Engines
- 8.1 Horizons, V-Drives
Rod, my starboard side lift sounds like it's gonna die any day now. I greased it in the fitting and the dam fitting popped off!! I was able to screw it back in and it's been holding, but the grinding noise is just awful. Any thoughts?
rcknecht
Well-Known Member
I have a single jack screw lifter... You have two... I am not sure why yours is making that noise. My problem is my motor is drawing too many amps. I took off as much weight as I could to make it easier for the actuator... It seems to be working, but I am not sure for how long...
boatmailster
Well-Known Member
I have one brand new DM12-10A5-18 for sale.
Kreole Kid
Active Member
- May 25, 2009
- 1,710
- Boat Info
- 2004 340 Sundancer - SOLD
2008 Yamaha VX1100 Jet Ski - SOLD
BOATLESS
- Engines
- 8.1 Horizons, V-Drives
Hey BoatMailster, is that for a 340? If so, how much are you asking for it?
---
- Sent from my iPhone using Tapatalk
---
- Sent from my iPhone using Tapatalk
boatmailster
Well-Known Member
this one is about 25" in closed position and 18" stroke. that size is used on most of sea rays. check your actuator size first. on some boats factory installed extension tube and if you have one of those, you will need to reuse it.
