Gofirstclass
Well-Known Member
sbw1 ,to avoid those ugly drip lines from thru-hulls, I came with this idea. Get a piece of clear vinyl tubing to fit the opening on the thru-hull. Cut one end square and the other at a 45* angle. Cut the square end at a length that fits well into the thru-hull and leaves the pointed end sticking out about 1/2".
When water comes down the thru-hull it runs out to the point and drips off there instead of running out and down the side of the hull.
If the tubing is too large to fit into the hole, cut a bit out of the length of it so it makes a tight compression fit.
When water comes down the thru-hull it runs out to the point and drips off there instead of running out and down the side of the hull.
If the tubing is too large to fit into the hole, cut a bit out of the length of it so it makes a tight compression fit.