WTB BRAVO 3 COMPLETE UNIT

[Hammer1970]

HELLO IM LOOKING TO BUY A BRAVO 3 COMPLETE UNIT 2.0 GEAR RATIO. HAD SO BAD LUCK AND HIT SOMETHING UNDER THE WATER AND THE UNIT HANDGRENADED INSIDE

 

[Bob Withum Sr]

That bites. Been there done that. I was at Russell Marine yesterday and got a new 2.20 Bravo 3, last one, but they have several 2.0's. he also had some new unit's that were $500. cheaper because that had minor issues, paint scratches or some just had Shipping container damage. But they are new B3'. They are in Worcester Ma. Hope this helps.

 

[Hammer1970]

thank you ill check them out

 

[boatman37]

Wow. I need to do a cone clutch replacement when we pull ours. For $500 I'd order one right now if it was the right one. Went to their site and don't see anything listed for Bravo 3?

BTW-how would I know what ratio mine is? It's a 2006 Crownline 250CR with a 5.7 260HP?. Not sure on the rating but it is a 5.7 for sure. Have 20P props and boat is listed as 6600lbs dry but actually weighs 7500-ish as it sits (CAT scale verified). I have my engine ID number but don't think I have the outdrive ID #. Engine ID is 0W383495 if that matters

 

[Hammer1970]

im not sure how to find the ratio i can find out for you. are you selling a drive ?

 

[scoflaw]

Merc customer service will give you your drive number from your engine number. They will give you a part number for your CC.

 

[boatman37]

Not selling my drive but was referring to an earlier post about a smoking deal on a new drive.

@scoflaw...aren't all the 2006ish B3 cone clutches the same?