zeehond_nl
Member
Hellothere,
I have aquestion about light layout on my 240 Sundancer.
I have aplan to change the standard bulb light (BA15S) into LED.
So I putone in but no light. After measuring the voltage I see that the positive (+)current was connected to the shield and the negative (-) to the center contact.
That’s thereason my LED will not light J
Is that amistake or is that normal??
Because Iwant the change all the bulb light in-side into LED I was thinking aboutchanging
thepositive/negative current by the source at the switch panel. I that a good ideaor do you guys have a better plan?
Greetings,Marco
I have aquestion about light layout on my 240 Sundancer.
I have aplan to change the standard bulb light (BA15S) into LED.
So I putone in but no light. After measuring the voltage I see that the positive (+)current was connected to the shield and the negative (-) to the center contact.
That’s thereason my LED will not light J
Is that amistake or is that normal??
Because Iwant the change all the bulb light in-side into LED I was thinking aboutchanging
thepositive/negative current by the source at the switch panel. I that a good ideaor do you guys have a better plan?
Greetings,Marco