Working Led Sys Monitor

[Skybolt]

I upgraded my sys monitor a few years ago to digital. This was working when it was removed. I had to replace two of the led's but everything works as is. The original owner had it connected to a terminal block and not the PCB. I don't have the ribbon connector PCB, so it's what you see here with a flat cut at the end of the ribbon cable. Cable is ~5' long. Buzzer works but not wired in correctly, needs power connection. Asking $250 shipped to cont. US.

EDIT: please pm to discuss price etc.

 

[Skybolt]

Bump -

 

[Skybolt]

Bump -

 

[Skybolt]

Last Bump ...

 

[Pgeee]

I’m surprised no one put their hand up for this. But I have a question. The unit in the pic you say you replaced a led, but my unit is fully sealed although it looks almost identical from the front? I would love to get inside mine to check leds and solder joints etc but looks impossible. Hence the question . I’ve read your extended detail on your upgrade btw. It might come to that one day

 

[Skybolt]

I’m surprised no one put their hand up for this. But I have a question. The unit in the pic you say you replaced a led, but my unit is fully sealed although it looks almost identical from the front? I would love to get inside mine to check leds and solder joints etc but looks impossible. Hence the question . I’ve read your extended detail on your upgrade btw. It might come to that one day

I used an exacto knife to get the red epoxy removed. I only had to replace the two lower LEDs. Past that good luck, that stuff is quite resilient.