won't rev over 3600 (fuel injector issue?) 7.4l

[km1125]

Personally, I'd yank out those screens and either clean them or replace them, and reinstall the injectors. Consider it a troubleshooting step. Might resolve the issue, or if not and you have to remove them again you KNOW when and where they were once clean (because you just did it) and could then start looking for the cause.

 

[1990dtgl98]

I bought oem reman injectors. I'll send mine out to get cleaned and flow tested.

I would up seeing rust in the regulator housing so I'm not sure how bad everything is. I blew it out as beat I could but the lines are NLA and unless I'm taking one from a junkyard, spending 500 on a used set online is a crapshoot.

I'll probably run it for 2 years and the ones I sent out to flow test ill swap back in and see how.much new rust is in the screens.