Window felts and gaskets

D

DogDave

New Member
Aug 3, 2011
18
Washington
Boat Info
24' Sundancer, gifted to me form my uncle. Rebuild transom, stringers, drive , engine.
Engines
Merc 260, GM performance intake manifold, 2.02 double hump heads, Reed cam.
I have a 79 sundancer that I have mostly restored. I am at the windows for this winters project. I have called and emailed Taylormade with no luck. Where can I buy new window gaskets and felts?
 
Hmm i will be following this one as I have not been able to figure it all out. Even have sample from Taylormade
Mike
 
The gaskets arent available,i soaked mine in bleach and hot water then cleaned and streched them a bit,worked well.The felts are available .taylormade products.com.They sell by the foot and charge a $25 cutting fee plus shipping.May want to get a few of you togeather before ordering and save a few bucks.The forwards section plexi is set in black rv window gasket tape which takes a few attempts to get in without screwing it up,i think i have a roll 100' for $14 from general rv.I would consider useing urethane next time instead of the tape,it can get very messy very fast though so have a friend you wont mind punching help you if you do.
 
http://www.crlaurence.com/ will have everything you need. The problem is trying to match what you have with right item.

They sell thousands of products but will not have any listing specific to a use.

I was fortunate to have an outlet close by. I just took a piece of felt track and seal rubber I salvaged to match with their stuff.

Got a perfect match and the cost was less than 10% of Taylor quotes.
 
Just so everyone knows, as of a couple months ago, Taylor no longer sells direct if you are looking for a part that is attached to a Brunswick boat. You have to go through your dealer.
 
I just got some of the side window flock ordered through my dealer from Taylormade and it was $45 for a 9 foot section plus the 25 service fee, but I received it in 5 days.
 
Thanks guys. This gives me enough to go on
 
Mike.. Do you have part numbers and the profile of the stuff you have? I have to do my 86- 270 and that might save me some time. Dave
Crave1957 said:
Hmm i will be following this one as I have not been able to figure it all out. Even have sample from Taylormade
Mike
Click to expand...
 
Taylor shut me down also....
 
You must log in or register to reply here.

Forum statistics

Threads
113,219
Messages
1,428,832
Members
61,115
Latest member
Gardnersf
Back
Top