Where can I get a table like this?

Quint4

Quint4

Well-Known Member
TECHNICAL Contributor
Oct 6, 2006
6,750
NC
Boat Info
CY 3375
Engines
7.4 MPI twin
I currently have a square cockpit table with a straight post mount. I would like to replace it with a smaller round table with the curved post like this:
I have seen these in 280 & 260 DAs.....who sells them?

cockpittable.jpg
 
They show up on EBAY- and on this forum every once in a while and I'm sure the a dealer would have one for $$$.
Just FYI check- it's not the straight post mount and it's REALLY SMALL- I hate ours cause two people can BARELY eat at it no way four....just making sure you're aware.
I'd sell you mine but I wanna keep it J.I.C.- sorry!
 
Quint, aside from the Sea Ray table, here's some other avenues: I don't know their websites offhand, but looking in my supplier catalogs, check out the following companies: Jet Technologies, Springfield, DetMar and possibly Wise.
 
The hardware - the upside down J leg and horizontal clamp on our 280 was made by Garelick. So you probably could order that from West. The frisbee is 22.5" in diameter and shouldn't be to hard to duplicate. To be real honest with you, I changed ours out because they look really cheezy and its too small for much more than a couple of beers and a bottle of sunblock!

Henry
 
Thanks to all, I will do some more googling. I know it's small, that's what I want. Just a spot for a beer or two and a bag of chips. My square table is impossible to get around once it's up.....so we never get it out. I like the idea of being able to swing the table over one of the bench seats if I want.
 
OK. You'll have to mix-n-match a bit, then. Henry is right about the manufacturer of the leg/clamp. They don't make the actual tables, though (at least not as far as I'm aware). IIRC, that particular table is an in-house, Sea Ray part.

The "swinging" part, as you mention, is a nice feature.
 
The table tops are pretty common....I suppose what I should have said is I need a curved pedestal mount....looks like Garelick makes 'em. Thanks everyone.
 
Quint4 said:
The table tops are pretty common....I suppose what I should have said is I need a curved pedestal mount....looks like Garelick makes 'em. Thanks everyone.
Click to expand...

I have this exact set up from our 2004 Sea Ray Sundancer 280. I had them up for sale in the fall with no takers.
Still looking to sell. PM me if interested
 
secret agent said:
I have this exact set up from our 2004 Sea Ray Sundancer 280. I had them up for sale in the fall with no takers.
Still looking to sell. PM me if interested
Click to expand...


Would that set up work for a 310 S.D. ??
 
If the 310 uses the same table arrangement as the 320, the J post may put the table in an awkward position. You could use a round top with the straight leg. That would center the table in the seating area. The 320 table is 31 x 18, so the round 22.5" 280 table would be a little close on the fore aft seats, but still within reach of the stbd side seat.

Henry
 
Thank you Henry....
 
PM sent. I have an extra circular table-top that you are looking for. Let me know if you are interested.
 
You must log in or register to reply here.

Forum statistics

Threads
113,184
Messages
1,428,132
Members
61,093
Latest member
Linword
Back
Top