Rapidroy5858
Member
Decided I needed to replace impeller on my 1990 sundancer with an Alpha 1 drive.
I originally dropped just the lower part of the drive found a melted impeller housing, replaced entire thing including base.
now trying to reassemble ...gave up on trying to slide lower half back onto upper just could not get it to slide together. I pulled upper half, was able to assemble the upper and lower back together, I had shifter in full forward, and the shoe on the drive facing forward, but when I slide it together the props spinning free, what am I missing?
side note/ question..when I attempted to put the lower half back onto upper half I noticed a splined tube dangling with a washer and cotter pin, I assumed this was a shift tube? Maybe I'm not getting this in proper placement?
Tired and frustrated,all help greatly appreciated!
I originally dropped just the lower part of the drive found a melted impeller housing, replaced entire thing including base.
now trying to reassemble ...gave up on trying to slide lower half back onto upper just could not get it to slide together. I pulled upper half, was able to assemble the upper and lower back together, I had shifter in full forward, and the shoe on the drive facing forward, but when I slide it together the props spinning free, what am I missing?
side note/ question..when I attempted to put the lower half back onto upper half I noticed a splined tube dangling with a washer and cotter pin, I assumed this was a shift tube? Maybe I'm not getting this in proper placement?
Tired and frustrated,all help greatly appreciated!