NWhippie
New Member
Does anyone know what the little knob in the center of the dash does? I assume it's the original trim tab adjuster and was disconnected when the rocker switches were installed but was just curious. It doesn't seem to do anything when rotated.
Update on my vibration and idle problem:
I installed the new fuel filter and everything seems normal. We took a longer trip on Tuesday and had absolutely no problems. :smt038 I suspect that gunk in the tank was the issue. Hard bouncing stirred it up and it got sucked up to the pickup. After turning off the engine, pressure was relieved and it settled again. Sound plausible?
I'm still seeking an answer as to what the little bulb device is inline before the filter. It's about 2" in diameter and upon closer inspection, it is plastic, not metal as I previously stated and has a wire coming out of it which goes towards the rear of the engine. Flow meter sensor perhaps? I don't think I have Smartcraft because when I check the SC box on my CP/GPS, nothing registers on any of the readings.
Eddie
Update on my vibration and idle problem:
I installed the new fuel filter and everything seems normal. We took a longer trip on Tuesday and had absolutely no problems. :smt038 I suspect that gunk in the tank was the issue. Hard bouncing stirred it up and it got sucked up to the pickup. After turning off the engine, pressure was relieved and it settled again. Sound plausible?
I'm still seeking an answer as to what the little bulb device is inline before the filter. It's about 2" in diameter and upon closer inspection, it is plastic, not metal as I previously stated and has a wire coming out of it which goes towards the rear of the engine. Flow meter sensor perhaps? I don't think I have Smartcraft because when I check the SC box on my CP/GPS, nothing registers on any of the readings.
Eddie