thought I share some pix of my Sonar/GPS installed

[Taradise]

I had MM at Allatoona in GA install this for me...I think they did a great job...now I cant wait to put it to some good use...

Here are some pix

 

[dpvandy01]

That stainless wire hole cover really looks nice. Sure beats the clear caulk I used

 

[Morpheus]

Hmmm did you steal my boat? Looks exactly like my install but I only have 1 cord to my Garmin 3205 and I used the rubber gromet that came with it. Nice Ram Mount but where did you get the end caps for the bolts I'd like to get some.

 

[Taradise]

Hmmm did you steal my boat? Looks exactly like my install but I only have 1 cord to my Garmin 3205 and I used the rubber gromet that came with it. Nice Ram Mount but where did you get the end caps for the bolts I'd like to get some.

they came with the RAM monnt...

 

[chuck1]

Great pics. What switch are you pulling your power off or does it even have a separate black box for the sonar that needs power.

 

[Taradise]

Great pics. What switch are you pulling your power off or does it even have a separate black box for the sonar that needs power.

it does not have a seperate black box...not sure really how it is wired...I do know that they are using the #14 fuse but are bypassing the ACCY switch...MM installed it and it is hard to follow all the wires as they are tie-tied together...

I hope this helps

 

[Nehalennia]

Looks good. The Clam shell does a nice job covering what must be an 1 1/8" hole to allow all of those wires. It sure would be nice if they could make a smaller wire harness.