Sorry to start a new thread but most of the others are old. I have a 2000 BR with the 3.0L Alpha II boat. Last summer I started getting the "Click, Click, Click" then it would start. Old car knowledge told me it was the starter going bad so I replaced it over the winter. When I brought it out to de-winterize it the boat would not start. I just get the dreaded "Click". All indication and voltage test confirmed the Stater Slave Solenoid was the issue. I changed out the starter slave solenoid and the problem is still there. All the solenoid does is Click. I can use the old check of crossing a screw driver to the terminals and the engine turns over but with the key only "Click". Now I'm confused. The chances of getting a bad solenoid are very slim but it could happen. I checked the wiring and everything looks connected. If it is the battery then when I cross the terminals it would not crank. battery is holding at 12.3 volts. The only thing that pops into my head is grounding for the solenoid. The ignition has 2 wires to the solenoid of which one is a ground. with 1 removed there's no click. I have no directions to go can you offer advise.