Michael Alvarez
New Member
my starboard tank always reads empty, need to replace the sending union but can figure out where the access point it. 2004 300 DA , any photo or video would be great.
Starboard fuel sending unit access 300DA
- Thread starter Michael Alvarez
- Start date
All's Well
Well-Known Member
Are you sure it's te sending unit and not the gauge?
I recently had a problem and presumed it was the sending unit but it was the gauge, easier to swap gauges to see if the readings are the same than buying a sending unit if that's not it.
I recently had a problem and presumed it was the sending unit but it was the gauge, easier to swap gauges to see if the readings are the same than buying a sending unit if that's not it.
Michael Alvarez
New Member
Garmin and regular gauge both showing empty
techmitch
Well-Known Member
- May 1, 2008
- 8,436
- Boat Info
- 1999 270 DA
- Engines
- Twin 4.3s W/Alpa I Gen II's
Test your wiring. An open circuit will read empty.
Michael Alvarez
New Member
Will do but still would like to find access to starboard tank sending unit
ZZ13
Well-Known Member
It's right on top of the tank easily accessible from the engine room. Port side is a lot trickier to get out. I put the formula for removing that side somewhere in the 300 Sundancer Questions thread around 2011-2012
Michael Alvarez
New Member
Found your thread, can’t find Royce sender anywhere but will keep looking
ZZ13
Well-Known Member
The Royce sender turned out to have reliability issues. I sold my boat not to long after I installed them so I didn't run into the issues. But I know several people that did.
Might be other puck style Manufacturers out there. Try searching the web.
FINAL DRAW
Member
- Jan 17, 2012
- 40
- Boat Info
- 1991 310 SUNDANCER
ACHILLES/ 6HP YAMAHA
- Engines
- TWIN 7.4 INBOARDS HURTH V-DRIVE
Measure depth of tank, sender from Wema Industries. Check them out. We and friends replaced originals. Seem great
