OK, I need some advise on a faulty Sea Temp reading I am getting from Smartcraft. I have the SC1000 Speedo with Dual TACH setup. I have an Airmar tranducer which I have confirmed is setup with Depth/Temp. I have gone in to CAL2 on the TACS to make sure the Sea Temp Sensor was enabled. I get a constant -31 reading on Sea Temp. My dealer said they connected a new tranducer and got the same reading on Sea Temp.
When I went to CAL2 on both TACS and selected NO, the reading came back as "OFF". When I re-enabled the Starboard Sea Temp Sensor on that TACH, it read 129-131 degrees, when I re-enabled the Port TACH, it went back to -31 degrees.
Does anyone have any idea on what is going on here? The transducer is plugged in to the "DEPTH TRANDUCER" 4 wire harness on the Starboard engine. As stated before, I checked the p/n and Airmar said it is Depth/Temp enabled and was built for Smartcraft.
Any Ideas? :huh:
Thanks
Jason
When I went to CAL2 on both TACS and selected NO, the reading came back as "OFF". When I re-enabled the Starboard Sea Temp Sensor on that TACH, it read 129-131 degrees, when I re-enabled the Port TACH, it went back to -31 degrees.
Does anyone have any idea on what is going on here? The transducer is plugged in to the "DEPTH TRANDUCER" 4 wire harness on the Starboard engine. As stated before, I checked the p/n and Airmar said it is Depth/Temp enabled and was built for Smartcraft.
Any Ideas? :huh:
Thanks
Jason