Smart Craft alarm

[JB MARSHALL]

Fired up the engines for launch earlier in the week and I received a waning alarm "Low Water Pressure" Engine 2 - which is port engine. So checked things out below and yesterday we did a shake down run and all systems ran/worked well. Engine temps were spot on @172 - 175 degrees. I tried to reset the alarm, went through the required steps as described in the manual and the alarm will not reset. I still have the alarm notification showing in the upper left corner of the smart craft screen. Does anyone have any experience with what might be the issue as to why it will not reset or if there may actually be a potential problem lurking?

Thanks
JB

 

[JB MARSHALL]

Update - So I checked the intake screen and no blockage. Took the impeller cover off to check condition of impelled and it's perfect. Still hunting this issue down.
Will locate the water pressure sensor and try swapping with the starboard motor and see what happens.