Shaft Size question - '86 Sea Ray 300 Weekender

[joenofish]

Would anyone know what the shaft sizes are on an '86 300 Weekender? Also, does anyone have a source for the shaft zincs? I also need to replace the heat exchanger pencil zincs (not sure what size they are either). Any info would be appriciated.

Thanks in advance,

Joe in St. Pete, FL

 

[jorge]

Hi, There i have a 300 sedan brige 1987 and it use 1"1/4 inch on the shaft. for the zink plates they have few size take the used one to the marine store near you..
good luck!
Jorge

 

[joenofish]

Thanks Jorge,

I don't have the old ones yet, diver tells me we need em soon, I'll stop at the local marine supply and pick up the shaft zincs, we are going to pull her right after christmas to do the bottom, I'll learn a lot then.

Joe in St. Pete

 

[fwebster]

A good source of information, if not the zincs themselves, is:

http://http://boatzincs.com/

Your transom zinc is probably a B-12 which is common to about every Sea Ray. You'll have to look up and match the engine, shaft and tab zincs.

 

[Pack66Dad]

My 1987 300DB has 1-1/4" shafts.

 

[AKBASSKING]

My 1987 300DB has 1-1/4" shafts.

Same here....

 

[1956olds]

mine are 1 1/4" also .Dont forget the ring that pushes water into the shaft tube for cooling either.

 

[ks65609]

Would anyone know what the shaft sizes are on an '86 300 Weekender? Also, does anyone have a source for the shaft zincs? I also need to replace the heat exchanger pencil zincs (not sure what size they are either). Any info would be appriciated.

Thanks in advance,

Joe in St. Pete, FL

Our 89 has 1 1/4 " shafts