El Captain Ken
New Member
Hi,
I have a 1998 230 bowrider. The Quicksilver Commander 3000 Remote Control went bad and I am replacing it with a Seastar Ch1751P. I'm having difficulty wiring it correctly.
The Commander 3000 had a four wire harness (purple, blue, red, green). The CH1751P has two (2) sets of three wire harnesses (blue, red, green). Any suggestions on how to correctly wire it so that the tilt and trim work correctly.
I'm assuming the two yellow (neutral) and two purple (emergency stop) connect the same as before.
Thanks,
I have a 1998 230 bowrider. The Quicksilver Commander 3000 Remote Control went bad and I am replacing it with a Seastar Ch1751P. I'm having difficulty wiring it correctly.
The Commander 3000 had a four wire harness (purple, blue, red, green). The CH1751P has two (2) sets of three wire harnesses (blue, red, green). Any suggestions on how to correctly wire it so that the tilt and trim work correctly.
I'm assuming the two yellow (neutral) and two purple (emergency stop) connect the same as before.
Thanks,