cruiser
Member
Hi all,
I'm in the process of rebuilding the rear seat bolster on my 95 370DA.I have all the wood cut(1/2" marine ply)with the exception of the small piece for the radius which I used 3'8 wiggle board.My question is what can I use to properly seal the wood? My thought was a polyester(boaters resin)on the edges then a light coat on the flat surfaces..If something else is needed.. would I still be able to drive staples(monel)through the resin or epoxy? Any help or suggestions would be appreciated.
Thanks
I'm in the process of rebuilding the rear seat bolster on my 95 370DA.I have all the wood cut(1/2" marine ply)with the exception of the small piece for the radius which I used 3'8 wiggle board.My question is what can I use to properly seal the wood? My thought was a polyester(boaters resin)on the edges then a light coat on the flat surfaces..If something else is needed.. would I still be able to drive staples(monel)through the resin or epoxy? Any help or suggestions would be appreciated.
Thanks