Sea Ray monitor system

[highball]

I have a 2000 410 DA and each year after the boat is launch I get a beep about every 5 to10 minutes from of the Sea Ray monitor system. It says all system normal. If I shut the breaker off in the panel in the engin room it will stop but sometimes it takes about 4 to 10 times for it to stop.I've had this boat since 2010 and each year is the same thing. Is there an other way easier or quicker to reset or stop this beeping . I tried pressing on the reset button, holding the reset button for about 30 seconds but doesn't do anything
Any info would be greatly appreciated
Thanks

 

[newfreedom]

I purchased a new monitor system because of this problem and never had to install it. I found out if I Disconnect the wire feeding the alarm & leave it disconnected for a few hours the problem went away. I still might have to do this over again sometimes but it is rare, maybe once a year. All systems are normal. My new SR monitor is still in its box.

 

[alubell]

Do you have any interest in selling the unused monitor

 

[newfreedom]

No interest. Always like to have spare parts just Incase.

 

[jff]

Just curious - mind sharing where you purchased that new systems monitor from and what it cost? Thanks (I may need a new one) ...

 

[rondds]

Can you have the engine's computer read to see if there's a code. Bad sensor somewhere probably.

 

[mistercomputerman]

Agree with Ron. Get the dealer to scan it or buy the Diacom diagnostic software and scan the ECMs for diagnostic codes. Barring a failed systems monitor, the boat is trying to tell you something. You should be listening.

 

[newfreedom]

Purchased at FPmarine.com