Sizzle
New Member
- Feb 4, 2018
- 9
- Boat Info
- 2007 250SLX
- Engines
- 496 Mercruiser with Bravo III Drive
Anyone replaced docking lights on a 250/270 before? After trouble shooting today I found I am getting good voltage at the lights so I'm guessing the lights themselves must be burnt out. I tried getting them out today but had no luck! Never thought it would be that hard. There were two screws on the back to remove what looked like a heat sink, but I couldn't get the light structure itself out. I tried the screws on the side, but they are attached with small nuts only accessible inside the light for a tiny, tiny finger. Any tricks to doing this?