Really need help bleeding a hynautic shifter system.

[Steve500dancer]

Aft r rebuilding the port side shifter lever at the helm we went to refill the system and purge out the air. Worked great on the port side that required the rebuild. However after hours and hours of trying to get fluid to the starboard side helm shifter we can't get it to bleed. We have tried bleeding it with the system pressurized and with it not pressurized.

The throttles and port side are all working fine now. Again it is just the starboard side shifter

Below is a picture that searay sent me of my particular system

Any help would be greatly appreciated

Sent from my iPad using Tapatalk

 

[Steve500dancer]

Ok I have an update on my issue. We now rebuilt the starboard side shifter and still have no fluid coming out from the bleeder at the std slave. Blew out all the lines and pressurized the system and nothing. It is almost like the exchange valve is stopped up. However we removed the valve from the bottom of the exchange valve directly under the starboard shifter line and cleaned it out. We just can't get fluid into that line for some reason.




Sent from my iPad using Tapatalk

 

[Steve500dancer]

All fixed


Sent from my iPad using Tapatalk

 

[fwebster]

So, what was the problem and what did you do to fix it?