Mechanic replaced raw water impellers and belts over the winter while boat was winterized.
Engines fired up and water flow is good.
However, I'm getting the following Smartcraft alarm: STBD Fault 36. Sea pump CKT High. I get this alarm if the engine is running or not. And the starboard water PSI shows 43.4 PSI with the engine off and when running at idle and up to 1500 RPM.
Mechanic would be happy to scan it.
I cannot locate the sensor to remove and inspect it. Can someone tell me where to find it?
This is a 2000 DA with 2005 8.1 inboards.
Thanks, Peter
Engines fired up and water flow is good.
However, I'm getting the following Smartcraft alarm: STBD Fault 36. Sea pump CKT High. I get this alarm if the engine is running or not. And the starboard water PSI shows 43.4 PSI with the engine off and when running at idle and up to 1500 RPM.
Mechanic would be happy to scan it.
I cannot locate the sensor to remove and inspect it. Can someone tell me where to find it?
This is a 2000 DA with 2005 8.1 inboards.
Thanks, Peter