SemperFi
New Member
"6.Now comes the hardest part. Loosen the clamps on the intake and exhaust hoses for the raw water pump and remove the hole assembly."
Your not kidding ... For a 240SD an added step to make it 1/10th easier ... Remove the hoses above the Y at the engine block ... This gives you better access to the hoses on the pump so that you can twist to break the seal and then pry gently on both sides of the hose ...
Thanks! ... Your guidance sure saved me a lot of time ...
Your not kidding ... For a 240SD an added step to make it 1/10th easier ... Remove the hoses above the Y at the engine block ... This gives you better access to the hoses on the pump so that you can twist to break the seal and then pry gently on both sides of the hose ...
Thanks! ... Your guidance sure saved me a lot of time ...