SeaAyeOwe
Member
- Dec 17, 2013
- 495
- Boat Info
- 2005 Sea Ray Sundancer 320
Merc. 350 MPI Stern Drives
Blue Hull
Zodiac C285S Dinghy w/ Yamaha 15H
- Engines
- 2 x MERCRUISER 350 HORIZON 300 HP gasoline engines w/Bravo III Drives
Guys - my raw water housings on the 350 mag's are the metal type and are rusted with small leaks so I am going to change them out.
I have bIII's.
Lifting out is not practical right now.
An ask for anyone that's has done this job in the water - I would like some advice.
I think the housings are below the water line, I can of course close off the sea cock but will the water flow back in through the BIII water intake?
Any advice on ten correct isolation and remove install procedure is appreciated.
I have bIII's.
Lifting out is not practical right now.
An ask for anyone that's has done this job in the water - I would like some advice.
I think the housings are below the water line, I can of course close off the sea cock but will the water flow back in through the BIII water intake?
Any advice on ten correct isolation and remove install procedure is appreciated.