CAMELLA
Active Member
I have a Raymarine C120 and the GPS works but the radar displays "NO DATA SOURCE". Does anyone have any ideas what it could be? Also when I turn the unit on it a data alarm goes out stating "NO FIX". Thanks!
Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature currently requires accessing the site using the built-in Safari browser.
I will try disconnecting the power at the radome. I climbed up there today and opened up the radome, all the wires were connected but I didn't have my volt meter to see if I am getting power.
I went down to the boat today and checked to see if I was getting power at the open array and I'm getting 12.8 volts, so no issue with power. I took the Raymarine 120 unit out of the dash and all connections are good. All switches are on including the autopilot as suggested above, what else could it be?
The switch is on and the radar worked a week ago, I went up on the hard top and checked the power at the open array. Right now we know there is power, the on and off switch is on, and all connections look good.
Did you check the connection on the back of the RayMarine C120 yet? I had one work loose before.
.... I took the Raymarine 120 unit out of the dash and all connections are good. ....
Bill, looks like this was checked according to this update...
... Just recently I had a problem with my Sirius weather module updated the C80 and even though it was still plugged in I had to remove it and re-seat it in the socket. Then it worked fine?? Electrical mysteries, sometimes the strangest problems turn out to be the old Microsoft solution…. “Did you re-boot your computer?”
The switch is on and the radar worked a week ago, I went up on the hard top and checked the power at the open array. Right now we know there is power, the on and off switch is on, and all connections look good.