Porthole screens 2003 260 sundancer

[BennyC1960]

Hi Does anyone know if you have to remove the screws inside the cabin and outside the cabin for the port hole windows to replace the screens? And secondly any place to find replacement screens at a reasonable price? Thanks

 

[Lazy Daze]

No, you don't.

Do you have the type of screens that are glued between the rubber seal and the frame, or do your screens simply pop-in and pop-out (plastic framed screen) of a groove in the rubber seal?

 

[BennyC1960]

Rubber seal

 

[Lazy Daze]

Rubber seal

Huh?

 

[BennyC1960]

Huh?

You asked if it was the rubber seal and I said yes

 

[techmitch]

You asked if it was the rubber seal and I said yes

There are 2 different types of the rubber seals. Which one do you have?

 

[BennyC1960]

How do I tell the difference? I’m not too handy

 

[Lazy Daze]

How do I tell the difference? I’m not too handy

I asked more than just whether or not you had a rubber seal - that part I know. Re-read my initial post. Then look at your portlights. It will be quite obvious.

 

[KevinC]

You asked if it was the rubber seal and I said yes

More than likely your setup was the same as mine on mine were when I had my 2003 260DA. These are not the pop-up framed screens like @Lazy Daze mentioned and your screens would be under the rubber seal for the window. I did not replace mine so I can not tell you how to remove the rubber seal unfortunately. I am sure someone here had done it though.

-Kevin