Parting out 1975 30' Express

L

liftbridge

New Member
Apr 11, 2009
29
Northcoast Erie
Boat Info
1981 SRV310
Engines
Twin 454 V Drives
I have a 75 30' Sea ray Express that I'm parting out. Anything you can think of please ask. I'm trying to keep the 255hp small blocks complete (1900 hrs.) Walter v drives, windshield, bow and stern rails, interior ok and much more. Engines roll over but I haven't tried to start them. NE Ohio (44004) for pick up or to take a look. I'll ship for cost, pic's on request. (thats my boat in the picture, not the one I'm parting out!) Thanks, John 4408121549.
 
Last edited:
Would you have the inside table and the post that it goes on? and if so what would you have to get for it? what are you asking for the V-Drives also? and the back stren wood rails, would you also have some pics of the boat also? thanks.
 
The hatches are not great but usable. If there for your 79 I think they are different. The 79 that I had used duel teak hatches in the middle with 2 engine hatched on either side. This has 1 large hatch with a teak insert. The horn looks aftermarket. Thanks, John
 
The table is in great shape however the post has surface rust. The v drives are untested but look good. When the boat was run last there were no issues with them. The teak in the stern is weathered and i've found some small cracks. I guess it depends how bad yours are. I'll get some pics. I'm thinking $50.00 for the table, $250.00 each drive. If you buy something I'll throw the teak in if you pull it. Thanks, John
 
What do the struts and rudders look like and can you see the stamped # on them?
 
is there a windless or front hatch supports or props
 
No windless or hatch supports. The rudders bolt on from the back of the transum, not through the bottom. The rudders and struts look in great shape. I'll check for numbers today.
 
How about the props for it? Do you have them and if you do could you get the #s on the props and pitch and what you have to have for them? sorry. also would you know if the v-drives would bolt up to my 454s big block? that are in my 1976 SRV 300. would you know what it would cost to ship the table and post to me in Rochester, NY 14609? thanks
 
Last edited:
Do you have a stern bench seat, or stren L shaped seat?
 
Do you still have the table and post it sits on for the boat? Would you take $25 and shipping for it? thanks. you never got back to me on this? thanks


liftbridge said:
The table is in great shape however the post has surface rust. The v drives are untested but look good. When the boat was run last there were no issues with them. The teak in the stern is weathered and i've found some small cracks. I guess it depends how bad yours are. I'll get some pics. I'm thinking $50.00 for the table, $250.00 each drive. If you buy something I'll throw the teak in if you pull it. Thanks, John
Click to expand...
 
Last edited:
You must log in or register to reply here.

Forum statistics

Threads
113,247
Messages
1,429,240
Members
61,125
Latest member
Bassinbradw
Back
Top