Pilot290
New Member
- May 29, 2020
- 23
- Boat Info
- Sundancer 290. 2000. Twin 5.0 efi Mercruiser, B2 drives.
- Engines
- Mercruiser 5.0 Efi.
Would normally go to the maintenance forum for this type of thing but it’s a bit specific to “older” 290 Sundancers.
my two bilge pumps both fitted to original SureBail float switches. (Photo shows arrangements after cleaning) the aft/lower pump works when switched on at the dash. I flooded the bilge (we r still out of the water!) but neither pump activated on the float switches. I’ve removed the float switches, they are free n clear but no pump activation when flipped. I’ve now disconnected the pumps and switches then reconnected to check if these had fails, still no action but the rear/main pump still ok from the switch.
From other threads I’m aware that there may be an inline fuse or two but I have no idea where they are and the wiring is well hidden. Electricians are as rare as Rocking Horse Shht around here so any help on here appreciated as to location of fuses or next steps. (I don’t have a multimeter n not sure I’d know how to use one if I had
Thanks in advance once again!
my two bilge pumps both fitted to original SureBail float switches. (Photo shows arrangements after cleaning) the aft/lower pump works when switched on at the dash. I flooded the bilge (we r still out of the water!) but neither pump activated on the float switches. I’ve removed the float switches, they are free n clear but no pump activation when flipped. I’ve now disconnected the pumps and switches then reconnected to check if these had fails, still no action but the rear/main pump still ok from the switch.
From other threads I’m aware that there may be an inline fuse or two but I have no idea where they are and the wiring is well hidden. Electricians are as rare as Rocking Horse Shht around here so any help on here appreciated as to location of fuses or next steps. (I don’t have a multimeter n not sure I’d know how to use one if I had
Thanks in advance once again!