bamafutbal
New Member
1. oil pressure sending unit needs replacing as it shows zero on gauge, was told gauge works so i believe the PO, just need to get part number for sending unit and order it
2. manifold on port side shows 100-106 degrees and starboard side shows 156-166 with IR gun and engine temp gauge is around 170-173, stays that way after long idle and a 30 minute run it actually cools it off 3-4 degrees. after 3 hours of ownership this is the max tmp i can achieve.
4. i want to replace 160 degree thermostat, do i need just the stat or whole kit with gasket
5. engine oil looks brand new but filter does not so will change both
6. just purchased a new fuel filter
7 will find someone to replace lower unit oil and impeller
8. just ordered new fresh water sink pump as it was missing
9. need to find the aft seat insert that goes at the walk through
10 trailer just got serviced
11. bilge works but the float has to be almost vertical, the dash switch will not let me turn it on manually
did i miss anything??????
2. manifold on port side shows 100-106 degrees and starboard side shows 156-166 with IR gun and engine temp gauge is around 170-173, stays that way after long idle and a 30 minute run it actually cools it off 3-4 degrees. after 3 hours of ownership this is the max tmp i can achieve.
4. i want to replace 160 degree thermostat, do i need just the stat or whole kit with gasket
5. engine oil looks brand new but filter does not so will change both
6. just purchased a new fuel filter
7 will find someone to replace lower unit oil and impeller
8. just ordered new fresh water sink pump as it was missing
9. need to find the aft seat insert that goes at the walk through
10 trailer just got serviced
11. bilge works but the float has to be almost vertical, the dash switch will not let me turn it on manually
did i miss anything??????
