njsr2002
New Member
Last fall I put in new manifolds/risers. They didn't seem to leak when I put them in, but this spring I see some suspicious looking rust stains around the elbow/riser joints. They are Barr brand and I used the cardboardy Barr gaskets provided. I did not use any Perfect Seal or anything else as per the instructions.
I'm going to try to torque them down again and see if that does it. If they are still weeping after torquing, should I put some perfect seal on them, or do I just replace the gaskets with Mercs ??
Thanks
I'm going to try to torque them down again and see if that does it. If they are still weeping after torquing, should I put some perfect seal on them, or do I just replace the gaskets with Mercs ??
Thanks