brewster16
Well-Known Member
Atwood series 3800 is the OEM for my 44 Sundancer. Those fixtures are all back ordered and I believe discontinued. Does anyone know of the LED replacement that is the same footprint?
Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature currently requires accessing the site using the built-in Safari browser.
Can't find replacements for my EC 400 either. 2-1/2" round footprint. :{Atwood series 3800 is the OEM for my 44 Sundancer. Those fixtures are all back ordered and I believe discontinued. Does anyone know of the LED replacement that is the same footprint?
Thanks, this is a 1 NM light, looking for a 2 NM, still it does look nice.Look up Atwood LightArmor. They are kind of teardrop shaped and are sealed LED with a telltale on top.
https://www.ebay.com/itm/322118906418?epid=9019995119&hash=item4affc87232:g:ey8AAOSwfCpbDaNQ
They make a 2nm version. I recently purchased a set.Thanks, this is a 1 NM light, looking for a 2 NM, still it does look nice.
Do you have pics of before and after? I would love to see how the look vs the original once mounted...Just installed a set of 2nm lightarmors on my boat as well. They are a smaller footprint than the 3800 but cover the old screwholes. And they are laser bright!
https://www.ebay.com/itm/201589982227
I can get a picture tomorrow, headin out to the boat after work. They are much improved over the old light. Full gasket underneath instead of that outer perimeter type gasket. Seal three screws inside and zero possibility for water intrusion.Do you have pics of before and after? I would love to see how the look vs the original once mounted...
Just ordered a set for my Cruiser!Just installed a set of 2nm lightarmors on my boat as well. They are a smaller footprint than the 3800 but cover the old screwholes. And they are laser bright!
https://www.ebay.com/itm/201589982227
Don't you just love when a manufacturer goes and discontinues your OEM and then changes the original size? Im sure someone at Attwood must have posed the question: "Maybe we should make the new and improved model the same footprint as the one that millions of boats already have on their bow?" Duh!Just installed a set of 2nm lightarmors on my boat as well. They are a smaller footprint than the 3800 but cover the old screwholes. And they are laser bright!
https://www.ebay.com/itm/201589982227
Thanks, this is a 1 NM light, looking for a 2 NM, still it does look nice.
Do you have pics of before and after? I would love to see how the look vs the original once mounted...
Looks really good! Should have mine by the weekend.
The LightArmor units have a nice long lead for easier install. They use 3 screws to hold them in the boat, so be ready to drill a couple holes. Snapping the stainless cover on is a little tricky - be prepared to press hard / give it a smack to properly seat it.
I did basically the same. The new unit covers the old holes, and some sealant filled them.Old holes are covered. I just smoozled some 3m4000 over and in the holes, reused the front hole, redrilled two rear holes, and sealed the three interior screws. Put a thin layer of 4000 on the gasket too. Zero leaks