JohnEGraham
Active Member
I Took the dingy out on the Swim platform yesterday which worked fine untill I returned and try to back in to my slip. Not good.:smt013 Almost wrecked it.
I need to lift the dingy on to the bow when returning to my slip. I will take the motor off at the rear and walk the dink to the front and use a couple of blocks with "D" Rings hooked to the oppisite Railing.
I fugure I could fip the dink over as I lift it up to the rail. Where I can lift in over.
I Can actually carry the Dingy ( 8 ft with wood roll up floor ) on flat ground but not on the Boat to bring to the front.
Anyone try this low tech lift?
Thanks. John G.
I need to lift the dingy on to the bow when returning to my slip. I will take the motor off at the rear and walk the dink to the front and use a couple of blocks with "D" Rings hooked to the oppisite Railing.
I fugure I could fip the dink over as I lift it up to the rail. Where I can lift in over.
I Can actually carry the Dingy ( 8 ft with wood roll up floor ) on flat ground but not on the Boat to bring to the front.
Anyone try this low tech lift?
Thanks. John G.
Last edited: