Leaking HPU - Do I need new nuts and a bracket???

[Alegria]

First off thanks so much for this forum. I learned so much in only a few minutes about the problem I am having with my tabs.

My HPU has developed a leak in the rear of the unit. Based on the threads here it looks like the pump seal has given out. Given this might be original equipment on my 1997 boat that is pretty good life. Also from the threads I see that this is not really a user replacement type ordeal so I am looking at just purchasing a new HPU.

So my question is this. Will my 1997 HPU fit in the existing bracket mounted there. Does this unit just slide in or do I need to remove the bracket, then the unit? Or just un-tighten some screws and slide it out.

Also should I order new nuts for the fluid lines or can the original nuts be re-used. They don't seem to have any issues... Of course fro $5 for the nuts I may just play it safe.

Only want to jam myself back there in the transom behind the muffler once!

Thanks!!

 

[Gofirstclass]

OK, I give up....what's an HPU?

 

[MonacoMike]

OK, I give up....what's an HPU?

Thank you!

MM

 

[MonacoMike]

Best guess after re-reading it: trim tab pump...

Hydraulic Pump Unit????

MM

 

[Phlorida]

Best guess after re-reading it: trim tab pump...

Hydraulic Pump Unit????

MM

Yep, Hydraulic Power Unit

 

[Larry&Leisa]

Bennett is very helpful if you contact them. I'm surprised TabMan hasn't jumped in here.

 

[Tabman]

Tom,

The HPU will fit in the bracket you have. It should slide out if you push up from the bottom and the new one will slide in from the top.

Usually you can reuse the nut and ferrule connectors on the tubing. But if you like send me a PM with your name and address and I will be delighted to mail you some new ones. no charge.

Tom McGow
Bennett Marine

 

[Alegria]

Yep you guys got it the power unit it is.

Tom thanks so much for the offer! More importantly thanks for the clarification on the bracket.

Tom your inbox is full.

 

[Tabman]

Tom,

I just cleaned up my mail box!