How can I clear codes in Smart Craft

[Nath]

I have two codes showing as active alarms, they are trim sensor related. They have both been changed out and still showing.
Is there a way I can clear the codes myself?

Any help is greatly appreciated!

Thanks in advance

Nath

 

[jason78]

Typically these types of alarms go away when the problem has been resolved and the ECM is turned OFF and ON. This is typically accomplished by turning off the ignition completely then back on. Another route if that does not work will be to disconnect the batteries for a couple minutes.

If that does not work, you either still have a fault with the sensors or someone with a Mercury DDT or Rinda Software will need to connect to the ECM and manually clear the faults.

 

[Nath]

Thanks for the reply Jason I'll try it this weekend. Cheers

 

[techmitch]

I think there is a place In Smart Craft to recalibrate the sensors. Were the sensors and trim limit switches replaced on both drives?

 

[Nath]

Hey techmitch as far as I know yes they were changed on both. Did recalibrate both showing in smart craft however I'm still getting active alarms for both. Thoughts welcome. Thanks


Sent from my iPad using Tapatalk

 

[techmitch]

Are the trim senders reading correct other than the codes and alarms?

 

[Nath]

Yes they seem to be working fine.