Ran jumper from y/r to slave, no change. Ran jumper from battery to to battery tab on key , no change. Barrel connector looks fine, I spread all the pins a little
On the back of the key is a red/purple connected to the battery terminal and a red/purple connected to the ignition terminal. Solid purple connected to accessories
Thanks scoflaw, I think this is taking me back to the beginning of this thread. When I turn the key to run I get 12v to ignition, when I turn it to start I get 0v to the ignition. That is while looking at the scan tool though, so I don’t know where at the ignition is getting zero. I will do as you said in a bit and get back with the results. Would the shift interrupt switch cause this? How can I test it?
disconnect y/r at slave. You don't have to do anything at the key. Your objective is to get a good strong source of 12v from the key to the slave. So jump from the r/p at the switch directly to the slave
Bad switch. You lost me on the previous post about reconnecting the y/r wire to slave. Don't do that yet. When you say jumping in post #94 your using the jumper wire correct?