Help i have water in my tilt and trim

[EDMAN]

Well I've looked and looked for info about changing the oil in the tilt and trim on my 99 215 EC. I have water in there and need to get it all out and find the leak. I found a manual type help but it wasn't the same type.
I don't see any drain holes in the resivoir and it sits almost on the floor.
It does seem a little loose. I don't see anything that looks like it might be leaking. Is this something the average guy can do? It looks easy to get to.

 

[Bt Doctur]

turkey baster works, drain and refill, remove trim hoses at the transom block, activate pump (up/down) untill clean oil at block,
the rearmost hoses of the rams are the up circuit, re-connect them ,make sure res stays full and operate the up circuit to raise drive all the way.
reconnect down hoses, operate pump making sure res stays full.cycle up/down twice and your done.
Water usually gets in the res from a high bilge water level.

 

[EDMAN]

Thanks I'll try that I don't see any way to get the darn thing off. I hope that works I don't remember any high water.